Fiat 500 Replacement Key Fob

It's possible to change the battery if your 500 remote key fob is not working. However, if you replace the battery but it continues to stop working then the issue is probably elsewhere.

At United Locksmith, we specialize in the creation of new keys for classic automobiles. We have all the tools and parts necessary to perform this service.

Dead Coin Battery

The most frequent reason why your Fiat 500 key fob will not lock or unlock the doors is a dead battery. The battery for the coin cell in the key fob will drain quickly when you don't utilize it often enough. If your remote started to show signs of weakness such as a loss in range and then completely stopped working The battery is probably dead.

Metal clips keep the battery securely inside the key fob. If the clips aren't tight enough, it could lead to problems with contact, which can prevent the remote from receiving power. By using a small flathead screwdriver, pull the retaining clip to remove the current battery, and replace it with a brand new one. Make sure to use a battery with the same size, voltage and specification as the original.

The key fob could also be damaged or corroded due to exposure to water. Even a short bath in soapy water may damage the electronic chip inside. It is recommended to keep your key fob in a dry environment.

Water Damage

If your key fob isn't functioning properly, it may be due to water damage. The rubber seals on key fobs prevent them from being damaged by a slight splash or drizzle of water. However, it's crucial to keep your keys from the washing machine, ocean, and the pool.

The key fob contains an electronic chip inside that transmits a signal to your car's immobilizer system. The chip allows the 500 to start and lock. If it gets wet, it will no longer work.

You can clean the inside electronics of your keyfob using isopropyl alcohol, or an electronic cleaner to see whether they're still in good condition. It is best to replace the key fob when it's submerged into salt water, rather than trying to repair it yourself.

Although a replacement fob may cost you a little bit of money, it's much less expensive than paying for your Fiat 500 to be towed to the dealer and repaired! Plus, you can do it yourself with a few easy steps. Be sure to have the correct type of battery before attempting to open your key fob. This is a job that's much simpler than it appears, and you can find step-bystep instructions online for nearly every key fob for your car.

Faulty Chip

The chip inside the key fob communicates directly with the immobiliser on your vehicle to ensure that the vehicle will only start when correct keys are inserted. If the chip is damaged, or corrupted in any way, your car will not start.

Water damage or a dead battery are the two most common reasons for a faulty chip. Regardless of the reason, it's best to delegate this work to a locksmith who will be able to replace the chip quickly and at a low cost.

If your key fob will not function after being exposed to water that is clean from the tap or rain take the battery off. Clean the electronic component with a paper towel. If the key fob will not work, there's the possibility that it's malfunctioning components and need to be replaced.

Some people will go to their dealer when in need of a new Fiat key fob, however this is a expensive option. United Locksmith is the best option if you want your fiat doblo van remote key (salas-faulkner-3.federatedjournals.com) key fob repaired at a reasonable cost. We have the tools and experience needed to repair your Fiat key fob in a timely and professional way.

Faulty Receiver Module

fiat 500 remote key programming key fobs transmit an electronic signal to the vehicle that will unlock and close doors (and start the car for vehicles with an automatic transmission) up to 50 feet. There are a variety of reasons why the fob might stop working. This includes a dead coin battery water damage or worn buttons and a receiver module issue or signal interference, or an electronic chip malfunctioning.

If the fob was in the pocket of someone who has suffered severe trauma (such as being dropped onto the hard floor or washed in a washing machine) the fob may not be able to connect with the Body Control Module (BCM) of the car. The BCM is a security system that can only accept signals from genuine original keys.

You'll have to replace the fob in case this happens. A professional locksmith will handle the entire replacement process including programming a new one for your 500. In fact, they could provide you with a clone key that functions exactly like the original fob (and costs a fraction of the price).